ATTI & STAB showing in cc3d

[Johanne]

Hi .

I purchased a new cc3d and configured and calibrated everything in libre Pilot.  Every thing was as normal and completed the wizard successfully.  But when tried to fly the drone it was very shaky . Uneven motor speeds . So o tied to look at the pc settings and found ATTI and STAB in red. Pic shared.

So 're did the calibration through the wizard. Every thing became green. But again the flight was very wobbly.  Plugged the cc3d in to the pc and found ATTI and STAB were in red again.

Need help to overcome this

Thanks
Johan

Sent from my SM-G615F using Tapatalk

[Johanne]

Hi .

I purchased a new cc3d and configured and calibrated everything in libre Pilot.  Every thing was as normal and completed the wizard successfully.  But when tried to fly the drone it was very shaky . Uneven motor speeds . So o tied to look at the pc settings and found ATTI and STAB in red. Pic shared.

So 're did the calibration through the wizard. Every thing became green. But again the flight was very wobbly.  Plugged the cc3d in to the pc and found ATTI and STAB were in red again.

Need help to overcome this

Thanks
Johan

Sent from my SM-G615F using Tapatalk

Photo attached

Sent from my SM-G615F using Tapatalk