So I made it a couple of days ago.
Flew it thrice everyday...had to get rid of servo for another project so made a final video on it.
One of my cheapest builds ( excluding the price of the 2.5g servos!!!.. >:( )
https://youtu.be/PGtVJuAR5OI
Flight video.
https://youtu.be/YV5L6sZEo2g
Safe to say I am not a good 3d pilot...just getting my hands on it....but it's fun...I wonder why I was flying airplanes like sky surfer all this time... Xd
Hi can u tell me how did u cut the thermacol sheet very neatly. Iam also trying to make like yours,but with a slightly larger motor (A2212 /13t 1000 kv motor).
great build and that's an awesome flight
Well firstly u need a sharp almost new blade...
Anything less than sharp will not cut thermocol properly...
Then use zero number sand paper to round off the leading edge very gently...patiently....
If you can find some other foam to make that's better....in my town only thermocol is available..so had to make do
{:)} {:)} Congratulations :thumbsup:
Congrats! Which motor and prop did you use?
Its a avionic motor... 2226 2500 kv....weighs 25 grams..if u use a 6*4 prop u get 290g thrust on 2s and 520g thrust on 3s...
I didn't use s.f prop...just normal E prop...
I am using a 12A ESC...20A would have been better..👍
Beautiful nice plane {:)}
Planning to make something cheap like this. :thumbsup:
Whats the cost of the electronics used?
Motor 630
Servos 350*3
ESC around 600
And some c.f worth maybe 150...
Servo too expensive....you can use 9,,gram servos...but they are heavy compared to 2.5 gram servos....
What battery do u use?
Its a 2s 300mah... By orange( sold on robu.in)
It was a 3s ..but I got rid of one cell coz I just had a 12 A ESC and not a 20A ESC...
Airplane weighs around ,190 gram or so..can hover vertical at around 70% throttle.....