Hi everyone,
Noticed that sanjayrai55 is:
1. Inspiring many with his coro builds
2. Using a LOT of balsa, esp for spars
Been looking for alternatives. One such is 'baton', or window beading.
Costs about Rs 2.50 per foot in 1/4" x1" size.
The problem is to strip it into 1/4"x1/4"
Here is my attempt (after many failures)
https://m.youtube.com/watch?v=G39Gc9VC37k
I have used this as it is as a spar in a SPAD.
What is the need of such strips?
Iyer sir
I have used the same for the spar of my wings and it also available in 1/2inch*1/2inch... Its used as fuselage for the moss glider.
Once a carpenter chiseled an 1/4inch*1inch into 1/4inch*1/4inch...
I guess chisel might make the work a lot easier...
Nice idea. Currently i am using the same stripe to make pusher plane.
Quote from: topalle on December 22, 2016, 09:41:09 PM
I have used this as it is as a spar in a SPAD.
What is the need of such strips?
Hi Srinivas
1. Weight saving
2. Cost saving
3. 1/4x1/4 potentially useable as spar, spar cap, longeron etc...
Hi Deva
Didn't have a carpenter or a chisel, but had the dremel and carbide cutting wheel...
Regards to both.