Hi,
i have completed building the new wattflyer mini plane borrowed from Shrikant. have a look at the pictures below







Electronics Specifications:
Motor   : 18-11 2000kv Micro Brushless Outrunner (10g)
prop     : APC 6x4 (one can assume the size of plane with this) 
ESC      : 10A
Battery : 2c 1000mah 20c
Servo   : 9 gms * 2
4 channel tx + rx
Others :
Fuse   : copy of Wattflyer mini
wing   : 3 mm split sheet of 6 m depron
ele     : 3 mm split sheet of 6 m depron
rudder : 3 mm split sheet of 6 m depron
Fuse front side construction is near to monoblock type, and motor is mounted on a piece of CCB (glass PCB)
Nose landing gear = original from Shrikant's model. Sorry Shrikant 
maiden will be on coming saturday.

Superb..Great stuff Sandeep Sir..

Nice   

Wish you had routed the motor to ESC connections below the fuse, to "keep the face clean" 

Thanks for the suggestion Anwar, Your wish will come true tomorrow, i will route wire inside the mono block itself.
i have noticed just now in the pic. that the wing dihedral is lost due to pressure of rubber band. i have to put wing struts to give a perfect dihedral.

STUPIDITY : I have painted / installed and give a small dihedral in wing in opposite direction. the fiber rods are coming on top of the wing instead of bottom.
will do the corrections today and upload the Pics tomorrow.
Sandeep

Great job done Sandeep... 

Lets see how the clone flies, So i can try and maiden the original    (after learning, that is  )

Nice job Sandeep. Where you plan to fly this ? some indoor stadium ?

Hi  Sandeep

Nicely done man!!!!! Looking forward to the video now. I have one question....where did you get the depron from???

I mean i checked out the Dadar shop you mentioned before and everytime i call them they say they are out of stock  

hav not been able to source depron n mumbai till now..

Regards

Ankur,
What ever sources are available in Mumbai, none are having the stock. one says that the stock will be available by 15th only.
Sandeep