Here are some pictures of my diy transmitter tray
I am using it for my Radiomaster TX16S.. but since it is adjustable both in width and height, it can be used with other TXs also
It is made out of 5mm acrylic sheet and have used 3x10mm brass standoff (amazon) joined in tandem.. the two angle rods for hanging are 8mm threaded rods (amazon)
happy flying
Nice finish Rahul. Here is my Tx Tray... made from plywood and Aluminium.
Good build 👍
Why does need tx tray ? We can use that neck belt instead right ?
The Tray keeps the TX in the position that is comfortable. Also provides the required support for wrist.. It make flying very comfortable.
Ohh, I see. The we can focus on flying and give less stress on wrists.
Great!
Can u give some dimensions for making the tray and i also have a question is there anything holding the transmitter safe in the tray ?
@Omkar. I made mine keeping my TX in mind. Dont have the measurements handy. Will post it next weekend.
Yes there are clamps to hold the TX in place on the lower side and the rear handle.
attaching the dxf file which can be used for laser cutting. It has been modified a bit, the holes/slots remain aligned.. you can use acrylic or ply.. For more comfort use it with a X strap
happy flying
rahul