HK QuadRotor Board

[ram singh]

Hello all friends, please help me.

My HK quad-rotor control board gyros are not working but throttle are working OK. But cannot found any effect on motors speed, after increase/decrease gyro trimmer or tilting the quad-rotor frame.
Sorry, my English is poor & sorry for any wrong write.

[anwar]

Note that the effect will be visible only at some amount of throttle.  If you just tilt it at zero or very low throttle, nothing will happen.  You will need a certain amount of throttle before you can notice the gyro action.

Also, please make sure you follow the setup procedure properly/exactly.

[AyushGupta]

Also while powering up ensure the gain potentiometers are in middle position as the extreme during startup make the code enter in settings mode...


Please follow these instructions...

http://www.kkmulticopter.kr/index.html?modea=manual


Hope this helps..... Just my 2 cents 

[ram singh]

thank you anwar sir and ayus gupta  I process............