Hello Fellas
This is my Quadkopter which is based on UAVX platform by Prof Greg Egan......
Although it is a bit unstable at the moment, but considering the time it took(more than one year) to roll out....it's of utmost satisfaction to watch it in air
- http://www.youtube.com/watch?v=bNSsIicvb60
Hi DesiClad
Welcome to the forum, ;D Your Intro ?
Nice :thumbsup:
The site below (which seems to be the one referenced by you) is offering ready to use boards, did you use one ? How much DIY was involved ?
http://uavp.ch
Quote from: augustinev on March 21, 2011, 01:44:39 PM
Hi DesiClad
Welcome to the forum, ;D Your Intro ?
Hi Augustinev ;D...
I am Anurag from Delhi.....I completed my Bachelor course in Electronics & communication last year from ITM, Gurgaon.....
I took this Quadkopter as my final year project......But couldn't execute it timely because of hardware issues.....
Anything else which I shall tell ??......please let me know
Regards
Anurag
Quote from: anwar on March 21, 2011, 03:02:44 PM
Nice :thumbsup:
The site below (which seems to be the one referenced by you) is offering ready to use boards, did you use one ? How much DIY was involved ?
http://uavp.ch
Hello Mr Anwar......
No I didn't bought the stuff from the place you have mentioned......Indeed I bought sensors( Gyros & Accelero) from Sparkfun & Board from Quadroufo.com........I got them soldered on board myself....
I couldn't do much DIY stuff myself, although I tried to it.......First I got someone here in Delhi to make bare PCB for the design of the flight controller....The guy made a horrible thing ( incomplete design, unmasked paths).....that experience was so much scary that I couldn't gather courage again to get it done again at my own......
I will post the photos of current Flight controller & the one that other guy made for me, pretty soon
Second issue was of programmer.....I tried programming the PIC mc with JDM based programmer but even that was nightmarish.....
and above all.......in last April I purchased Gyros & acceleros different from the std. ones used with that project, in the hope that I would be able to make alteration in original design and codes as per my requirement......but the first two experiences didn't gave me that much flexibility......
So finally I decided to give up thought of doing something at high level and just finish as it up by least time consuming method (although that was really embarassing).....
Regards
Anurag
Quote from: anwar on March 21, 2011, 03:02:44 PM
http://uavp.ch
Anwar,
This link dose not open, any other link for the same?
Ah OK got it.
http://uavp.ch/moin/FrontPage
Right, the first one will redirect automatically to the one you posted.