Hai every one
While I was building my blue baby 42 Styrofoam cutting was needed, So I made a styrofoam cutter from Nokia phone charger which has an out put of 5v/800 milli amp The wire used is a nichrome wire and the bow span is 40 cm.it is cutting great.Hope help some one.
it"ll help to everyone . . . post videos and plan of your new cutter
That's great mate. Step by step tutorial would be great.
+1 Dharmik
Nokia chargers are smps based, i think you should use a auto bulb in series for safety otherwise it will blow your charger.....this applies on transformers base cutter too...... :hatsoff:
yes it will blow up , there may be chances , i have had an experience ,
ok there should also be any other similar good way of building foam cutter , any idea ?
i use a simple one...
wooden bow ( just like the real bow) using heating element from induction cookers( get some from repair shop or spareshop) a 12V 3A step down connected directly.... works good
the tension in the bow will help it stretch,, and not sag