Text only | Text with Images

RC India

RC Equipments => Servos, Gyros and All Electronics => Topic started by: Immanuel on September 30, 2015, 10:49:04 AM

Title: apm 2.6 compatible for vtail setup
Post by: Immanuel on September 30, 2015, 10:49:04 AM
Hi everyone,
I've been wondering if can Load arduplane in a apm2.6 and configure it to fly a vtail , all i need to do is mix it correctly right?, do i need to buy a vtail mixer ?

Thank you
Immanuel
Title: Re: apm 2.6 compatible for vtail setup
Post by: subhashjk0508 on September 30, 2015, 12:03:58 PM
APM supports v-tail. No need for any mixing. And if you don't want apm on v-tail. You can just fly it in elevator, rudder and add on a external v-tail.

JK
Title: Re: apm 2.6 compatible for vtail setup
Post by: Immanuel on September 30, 2015, 04:15:23 PM
What is an external vtail ? I've attached a picture of my frame too for your reference, will I be able to directly hook up an apm 2.6 to it without mixing?
Title: Re: apm 2.6 compatible for vtail setup
Post by: subhashjk0508 on September 30, 2015, 04:17:59 PM
You can just directly hook up the APM and enable v-tail. Just Google on it. And by external vtail i meant a external v-tail mixer available for a dollar our two.
Edit- no mixing required on radio.
JK
Title: Re: apm 2.6 compatible for vtail setup
Post by: subhashjk0508 on September 30, 2015, 04:23:06 PM
Follow this link to set it up. Don't put on any v-tail mixing on radio or external.
http://plane.ardupilot.com/wiki/reversing-servos-and-setting-normalelevon-mode/

JK
Title: Re: apm 2.6 compatible for vtail setup
Post by: Immanuel on October 01, 2015, 01:34:54 PM
Thanks  subhash :)
Title: Re: apm 2.6 compatible for vtail setup
Post by: subhashjk0508 on October 01, 2015, 02:03:15 PM
(Y)
Text only | Text with Images