Hello, I have an APM 2.8 (2.6 clone), accidentally i broke it's usb. When I tried to resolder it, and when I connected to my pc, it shows not recognized. It's working fine. Can anyone tell me an alternative to usb. I have a Telemetry but when I tried to upload firmware, it shows can't upload. Please help!
Bump
Can you post a pic?
Dude , only the usb is broken.
A damn pic would show if anything else is broken as well. Please post a pic, at least after you've soldered it ;D
apm is basically atmega 2560
findout where the isp headers are and use an avr programmer to flash
the firmware using arduino interface
or flash direct using avrdude ( which the arduino interface also uses)
After I soldered t, It got broken once again. So, I trashed the usb. Will try the above thing.
Pic
It's a portraited photo! Nothing that's necessary is visible. Man, you're so great!
As @saikat sir has already mentioned, upload it via the headers.
Also check if you have done any damage by soldering it. Most probable is a short ;D
Is that solder pads is good? I recommend you to join microsoldering group in facebook. Group members of that group will help you in this.