nothing on it .
the pdf manual ?

just researched, you can use a configuration file to get back the ct6b to factory settings,
http://www.rcgroups.com/forums/showpost.php?p=20539589&postcount=172

Tred it . Doesnt work

some issues here.

T6Config is not working, SO im using digitalradio SW and it doesnt recognize it.

When you connect your cable, is it detecting ? (as a COM port ?)

yea, red led comes but the SW doesnt open

try reinstalling the software.
you may get more help from ct6b users, if you post exactly what is happening when you connect Tx to pc with screenshots and pictures.

may be something wrong with driver installation.

idk digital radio works and reads fine. t6 doesnt open

try reinstall - and pls post the exact details of your problem.

ok it opens, I dont understand anything there how do I proceed ?

just download the link in Reply #26

extract that file to desktop

open T6Config
click settings
select your com port , press ok
click open
select file extracted from desktop


done.

http://www.rcgroups.com/forums/showthread.php?t=1390731

I have this SW

T6 got updated i guess

What to do now ?

anyone ?

If someone here uses the CT6B ? PLEASE save your settings and give it to me ?

if you are asking for T6Config, please read  Reply #35 again.

for T6Configuration

select com port
just connect
click new configuration
click default configuration
click send configuration

done

not happeneing .

No matter what i do, some weird issue is happening here:

ill explain:

I did the default thing, Tx ON
Connected the battery
ESC beeps
Board lights up
the startup text for half a second
backlight of the board slowly reduces
after 5 sec
servo jittering
board rebooting on seconds basis ( ON OF ON OFF ON OFF )

what do i do ?

Parichya, what is your problem here Radio or KK2 or your PC

It's all mixed up.

PC is fine
SW is working
The issue is something related to the TX i guess

If i switch off the TX and boot the the board, it works fine ( No input found comes)

but if i boot it with the TX on , the event i mentioned happen

WOW this is strange>

I took out the servo Leads from my Rx and the board booted fine ( not arming though )

disconnect servo and power up, do that restarting now?

Edit: please ignore this question, you answered this already.


power to servo is taken from rx right?
that means all servos are taking power from 1 BEC.

yea they do .

Now reconnected them back and they work fine

Only issue now is that my board is not arming

Quote from: parichya.gautam on January 07, 2015, 12:23:42 AM
yea they do .

Now reconnected them back and they work fine

Only issue now is that my board is not arming

but i am sure that this will happen again if you take all power from 1 BEC.

WOW, the the servo issue is back plus board is not arming too >>> What is happening !

They were working fine all this time ...

akhilzid PM