I brought glue gun long time back from the ebay, with no temp control. I found difficult to control the flow of melted glue. When I trigger melted glue comes out, but I noticed that after the use, it starts dripping. I think, I'm not squeezing too much. Are you facing similar issues?

Even I keep glue gun in vertical standing position (keeping the nozzle upside), few drops of glue comes out... 

Please share your tips / tricks 

Regards,
Dileep

Hello,

i purchased glue gun a week ago for  :Rs:120/-
working nicely

keep sm points in mind.........

Plug the gun for getting hot
keep in position of down nozzle over aluminium foil
keep pressing trigger at sm interval
wen glue starts coming out
wipe nozzle over foil & point towards applying surface
Use trigger to ooze out glue
If glue is coming in excessive amount automatically
swich off for sm minute


Glue may continue to ooze out of the gun even when you aren't squeezing the trigger. When you set the gun down, make sure to place a sheet of  aluminium foil to   prevent surface.

Watch it