hi!
recently, i was charging my cordless drill battery, and there was fluctuation at home, and the charger blew.... 
now i cant use the drill because i cant charge the battery... searched around in shops for another charger, but no luck because it's a chinese drill and they don't keep stuff for these...
so i was wondering, can i connect my LiPo to this? it is a 12v drill, so if i connect my 2200 3s 25c, can i use it? or will i need one with a higher discharge?
or is there a way to charge the battery with my lipo charger? i have an accucell 6,

here are some pics for better reference

this is the battery:


and this is the points inside the drill(left one is +ve )


and these are the points on the battery... i cant figure out how to charge it, because i dont know what to do with the "ground" pin...



thanks !
aniket

Try it on the charger, at low amperage (< 0.5) at first . The charger should automatically detect number of cells.

You could also get the original charger repaired. If you know the charge rate & trickle rate you could buy another charger

@sanjay sir, what battery type do i set it as? its got these cardboard like cells inside,, but nowhere does it mention what battery type it is

Your accucel can easily charge this pack -

To identify battery type count the number of cells
If 10 nos then its either NiCd or Nimh - to be on the
safe side charge at Nimh setting at 1500 mah charge rate.
If 3 nos then LiOn - charge at you normal Lipo setting 3s
Seeing the drill quality - it is unlikely to be Life

you can also connect your lipo to the drill - the original
pack is 1.5 ah or 1500 mah so your 2200 mah pack
should easily be able to power your drill.

Saikat has good advice 

You should also read this:  http://www.rcindia.org/rc-general-topics/learning-about-batteries/msg74882/#msg74882

aah! it works!!! thanks guys!