i want a esc for HobbyKing Donkey ST3511 motor 810KV
i think 30a esc is not saficient for it,, bec it brunt in one minute flight,, it comes in combo pack.
this hapend
but it comes in a combo pack... how could it be wrong. :banghead:
how many do you want??and of what amps??
one esc i think 40A is suitable for this motor
specification of motor...
Specs:
RPM/v: 810kv
Dimensions: 42 x 29.5mm
Shaft: 5.0mm
Voltage: 6v~18v (2~4s lipo)
Weight: 170g
No-load current: 2.0A
Max Current: 35A
Max Watts: 360W
Mounting Holes: 52mm
pl suggest me sutable ESC,,,,,,,
on the hobbyking site it is 30 amps either its the esc that came defected or there was a short(did any of the two wires touched each other and did u use heat shrink??) ,to be safe it is recommended to use an esc which has the amp rating 20-30% higher than your motor in this case the motor takes the max current 35amps so you should use a 40 amp esc ...i had the same problem so i bought an 30amp esc for my 25amp motor and now it works fine(but be sure not to use an esc which has a very high rating like an 80amp it can damage the motor)...im telling u this by experience but if im wrong, correct me...
regards
rohan
my model flys for one minute and after that esc got heated very much,, its plastic cover melted down due to heat...
can i use 40A esc with this motor
yes u can but ask somebody before and what battery were you using???
3s 2200mah 20c-30c battery
then it was either the short or the esc was not compatible with the motor...get a 40amp esc then
One important data is missing. what prop have you used?
Just googled this and found that ive already used this motor and it was a Crappy motor you could ever get.
Bushing will give noise like 10th run, mount breaks easily due to poor aluminium!!.
Okay , here is the good news, ive used it on a 8x4 prop and 20A esc and it was all fine.
a little warm after a minute or two of run.
Ashok.P
I am using 10*6 prop
Quote from: v2 eagle on September 08, 2014, 09:58:28 PM
One important data is missing. what prop have you used?
Just googled this and found that ive already used this motor and it was a Crappy motor you could ever get.
Bushing will give noise like 10th run, mount breaks easily due to poor aluminium!!.
Okay , here is the good news, ive used it on a 8x4 prop and 20A esc and it was all fine.
a little warm after a minute or two of run.
Ashok.P
Sir,
Are you thinking of the smaller Donkey ? 2204 perhaps?
Both i and devashish (on this forum) used the Donkey 2204 combo. With 8x4 props.
I, on my little bipe, Devashish on his 3d.
Both more than satisfied.
This 3511 is rated for 12x6 props!
No Iyer sir,
The one with 4mm Shaft. the motor mount bent on very first nose crash. Magnets got rusted like few months later.
will post pics probably by tomorrow on the motor can(Thats all is left). the looks itself a little intimidating. you would not believe how bad the magnets inside look like. the shaft is still strong though. and thrust is good for the size but not the quality.
Ashok.P